Time: Sets the delay time, from 0ms to 1.5 seconds.
Repeats: Controls the regeneration of the delayed signal. Also acts as a enhancer for the reverb. In reverb mode this will control the thickness, decay, depth and overall nature of the reverb.
Reverb: Clockwise for more reverb, counterclockwise for less.
Mix: Adjusts the over all level of the effected signal.
To use as a reverb only, turn the time control all the way down and adjust the reverb and mix controls to taste. In this mode, the repeats control can be used to enhance the thickness, decay, depth and overall nature of the reverb. With the reverb control at its maximum setting, the repeats control will gradually overload the effect at higher settings.
To use as a delay only, turn the reverb control all the way down and adjust the time, repeats and mix controls to taste.
To use both effects in unison, adjust all controls to taste.
True bypass and hand made one at a time in landlocked Akron, Ohio.
4.37″ X 2.37″ X 1.75″ with knobs
Our pedals take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. Do not run at higher voltages! Current draw is 60 mA.